When drying plastic granules, it is important that the equipment is properly dimensioned to get the best results at the lowest energy consumption.

The correct speed of material conveying is important to avoid unnecessary wear and tear on the equipment or to prevent the material being conveyed from being destroyed. Fast conveying means a higher energy cost as much of the energy goes to increased friction energy.

Volumetric equipment doses by volume and gravimetric equipment doses by weight. Volumetric equipment needs to be adjusted for each material with a new bulk density to provide a correct value. When using gravimetric equipment, you can be closer to the limit value and have a smaller safety margin than with volumetric dosing. You can often save the extra cost of gravimetric equipment quite quickly just by doing this.

New blades are sharper and give a better cut in the plastic. Sharp blades generate significantly less dust and the milled material is easier to feed back directly into the process.

We have a lot of pipes, assembly materials and hoses in stock, which enables us to offer a quick delivery time. Large quantities or odd dimensions are not always in stock so the delivery time may be longer.

We have both new and used equipment in stock as shown under “Used and Stock” in the product menu. Not all items be displayed on the website, so please contact us if you are looking for a specific product. Sometimes stock items may also be held by our suppliers.

Yes, we manufacture our own products under the Cemec brand. These are products that we have been developing for a long time. Many of the products have been developed for a certain project, but are too good not to be used again. We have built up a network of workshops that we use in our vicinity. This gives us good control over quality while also giving us the opportunity to reduce our environmental impact.